Opened 14 years ago
Closed 12 years ago
#12 closed defect (worksforme)
E1000E driver doesn't work in case uniaud debug also loaded
| Reported by: | warpuser | Owned by: | |
|---|---|---|---|
| Priority: | Feedback Pending | Component: | e1000e |
| Version: | 0.1.4 | Keywords: | |
| Cc: |
Description
the e1000e driver will load with no error message at bootup, but then netbind and ifconfig fail because of the missing interface, with the uniaud retail driver all is working fine. Uniaud reports itself as Uniaud32 version 2.1.3-BETA SVNr550-DEBUG. As there is no debug version of the e1000e driver available no additional logs are provided.
Change History (2)
comment:1 by , 13 years ago
| Priority: | major → Feedback Pending |
|---|
comment:2 by , 12 years ago
| Resolution: | → worksforme |
|---|---|
| Status: | new → closed |
No response from reporter. Cannot reproduce the problem.
Note:
See TracTickets
for help on using tickets.
Version 0.1.4 is an old version. Please use the current version.
You should not be using debug versions of ANY drivers unless you are actively debugging a problem. Debug versions *never* work as well as the normal versions and may not work at all. In addition, debug versions use much more system resources than the normal versions and can cause your system to run out of needed resources which will cause other drivers to fail. This is especially true for the uniaud driver. This is not a defect in any of the drivers. That is just the way it is.
Nevertheless, I tried the current E1000E driver with the debug Uniaud32 driver installed and it worked perfectly for me.
So unless you can provide enough information to reproduce your problem, I will close this ticket.