Opened 8 years ago
Closed 6 years ago
#349 closed enhancement (fixed)
Change the "Save As" FOC behaviour to allow selection of TARGET filename
Reported by: | darcio | Owned by: | Gregg Young |
---|---|---|---|
Priority: | major | Milestone: | 1.4.1 |
Component: | UI | Version: | 1.4.0 |
Keywords: | Cc: |
Description
This is an Enhancement request.
I would like the ability to simply point to an existing filename as a TARGET destination in the FOC dialogue box during the "Save As" operation.
Today I can not do so, instead I have to re-type the full TARGET filename. This is tedious and replacing it with a quick "point and click" would make the saving process to much quicker.
This request may be similar to #330 (http://trac.netlabs.org/lucide/ticket/330), although I think there are specific differences here when it comes to the clean-up tasks for where there original PDF file was located (this strictly deals with on-line PDF content viewing).
Change History (4)
comment:1 by , 6 years ago
Milestone: | 1.4.0 → 1.4.1 |
---|
comment:2 by , 6 years ago
Owner: | set to |
---|---|
Status: | new → assigned |
comment:3 by , 6 years ago
Gregg, Any chance this will be in 1.4.1? I just tested your RC2 and I do not see it yet...just curious, no biggie. Thanks, -Dariusz
comment:4 by , 6 years ago
Resolution: | → fixed |
---|---|
Status: | assigned → closed |
Note this was specific to the IBM FOC CS 690
Ticket retargeted after milestone closed