Custom Query (34 matches)
Results (22 - 24 of 34)
| Ticket | Resolution | Summary | Owner | Reporter |
|---|---|---|---|---|
| #34 | fixed | OS2AHCI not working on TP T510 | ||
| Description |
When booting with Danis and in Bios compatibility mode it works. When i switch to AHCI in Bios AHCI gives me: Found AHCI device Intel PCH AHCI (0:31:2 8086:3b2f) class:0x010601 And after that i get a: OS/2 is unable to operate your hard disk or diskette drive. The System is stopped The OS2AHCI.ADD is version 1.31 from 8th August 2013 |
|||
| #5 | worksforme | Possible defect in OS2AHCI driver when booting from CD ROM | ||
| Description |
While testing for bug 4 I booted of the eCS 2.1 CD ROM with the OS2AHCI.ADD loaded. When I then inserted a DFsee in the CD ROM drive and went to drive S: on the command line and typed DIR I still got to see the old content of the eCS install CD (eCS 2.1 CD #1). I don't know if this is a problem of this computer specifically system or the AHCI driver in general. |
|||
| #4 | fixed | Possible geometry bug ?! | ||
| Description |
The following scenario we have: A machine that runs in legacy and AHCI mode in the BIOS. We switch the machine to legacy mode and run with Danis506.add version 1.8.9. On a 1 .5. TB driver I installed boot manager first. Then I create a primary 200000 MB partition. Then the rest of the drive gets allocated by a logical partition of about 1.3 TB. Both partitions are added to the IBM boot manager. I can format the volumes and they are also listed in the installer as being volumes to which eComStation can be installed. Then when I switch the BIOS to AHCI mode and load OS2AHCI.ADD driver (version 1.12) everything seems to work just fine! But when I get to the installer page of eCS 2.1 I get the message no instable volumes where found and that the disc manager will be started (minilvm). In the table where it says "notes" (the last column to the right in minlvm) it normaly mentions "Bootable " if a volume is added to the boot manager. Now with the AHCI driver loaded does "bootable" flags are gone. If I again load the system in legacy mode and with the DANIS506.ADD driver the bootable flags are displayed again in minilvm. LVM does not give any error message when its get started. Attached is danis506.txt which is the output of lvm /startlog:. And OS2AHCI.txt which was created with the OS2AHCI.ADD loaded. So it seems the LVM code is not able to read a portion of the disc. I presume the flags that tell bootmanager what partitions are stored in the bootmanager partition which is at the beginning of the disc. Is this some kind of geometry problem ? |
|||
