e1000e hangs during netbind - e1000e-0.2.1 on Lenovo ThinkPad T510

[Doug Bissett]

E1000E-0.1.8 worked perfectly. E1000E-0.2.1 says it loads, but the system stops booting at NETBIND.EXE, and never proceeds. There is no LANTRAN.LOG file. I must force a power off to be able to reboot.

[Doug Bissett]

Bus 0 (PCI Express), Device Number 25, Device Function 0

Vendor 8086h Intel Corporation
Device 10EAh 82577LM Gigabit Network Connection
Command 0107h (I/O Access, Memory Access, BusMaster, System Errors)
Status 0010h (Has Capabilities List, Fast Timing)
Revision 06h, Header Type 00h, Bus Latency Timer 00h
Self test 00h (Self test not supported)
PCI Class Network, type Ethernet
Subsystem ID 215317AAh Unknown
Subsystem Vendor 17AAh Lenovo
Address 0 is a Memory Address (0-4GiB) : F2600000h..F261FFFFh
Address 1 is a Memory Address (0-4GiB) : F2625000h..F2625FFFh
Address 2 is an I/O Port : 1820h..183Fh
System IRQ 20, INT# A
New Capabilities List Present:

Power Management Capability, Version 1.1

Does not support low power State D1 or D2
Supports PME# signalling from mode(s) D0, D3hot, D3cold
PME# signalling is currently disabled
3.3v AUX Current required : 0 mA (Self powered)
Current Power State : D0 (Device operational, no power saving)

700 mW D0 power consume
700 mW D0 power dissipate
200 mW D3 power consume
200 mW D3 power dissipate

0 mW common logic power consume

Message Signalled Interrupt Capability

MSI is disabled
MSI function can generate 64-bit addresses

Unknown Capability (Code 13h)!!

[David Azarewicz]

Can your system do a trap dump?

[David Azarewicz]

Version 0.2.2 was released today which resolves the hang problem. Please try that version.

[Doug Bissett]

Version 0.2.2 seems to have fixed this problem.