Custom Query (41 matches)

I have a Realtek ethernet driver working with RTL8169 driver from eCS 2.0. For that driver I need to specify NetAddress?. I installed beta 1, and networking does not start.

Output of ifconfig and lantran.log are attached. PCI dump of the ethernet adapter follows.

Bus 3 (PCI Express), Device Number 0, Device Function 0

Vendor 10ECh Realtek Semiconductor Co., Ltd. Device 8168h RTL8111/8168B PCI Express Gigabit Ethernet controller Command 0007h (I/O Access, Memory Access, BusMaster?) Status 0010h (Has Capabilities List, Fast Timing) Revision 03h, Header Type 00h, Bus Latency Timer 00h Self test 00h (Self test not supported) Cache line size 32 Bytes (8 DWords) PCI Class Network, type Ethernet Subsystem ID 0DC4105Bh Unknown Subsystem Vendor 105Bh Foxconn International, Inc. Address 0 is an I/O Port : E800h..E8FFh Address 1 is not present or not configured! Address 2 is a Memory Address (64-bit, Prefetchable) : DEFFF000h Address 4 is a Memory Address (64-bit, Prefetchable) : DEFF8000h System IRQ 11, INT# A Expansion ROM of 128 KiB decoded by this card, currently disabled New Capabilities List Present:

Power Management Capability, Version 1.2

Supports low power State D1 Supports low power State D2 Supports PME# signalling from mode(s) D0, D1, D2, D3hot, D3cold PME# signalling is currently disabled 3.3v AUX Current required : 375 mA Current Power State : D0 (Device operational, no power saving)

Message Signalled Interrupt Capability

MSI is disabled MSI function can generate 64-bit addresses

PCI Express Capability, Version 2

Device/Port? Type :

PCI Express Endpoint Device

Device Capabilities :

Unsupported Request Severity is Fatal

Device Status :

Correctable Error Detected Unsupported Request Detected AUX Power Detected

Link Capabilities :

Maximum Link speed : 2.5Gb/s Maximum Link Width : x1 Link Port Number : 0

Link Control :

Common Clock Configuration In Use

Link Status :

Current Link speed : 2.5Gb/s Current Link Width : x1

MSI-X Capability Vital Product Data Capability

VPD Data not present

e-co:

VER: Realtek Ethernet R8110 driver 0.1.2 (20110214)

Device: 8169

The driver boots OK. usually works fine.

There is one problem:

it is working during several days or hours..

sometimes netbios/tcpip connection stops to work.

network H:\ drive disappears.. computer doesn't respond. Reset.

I just installed R8110 beta 2 driver, and now networking is not working. the driver seems to load correctly, but LANTRAN.LOG reports

IBM OS/2 LANMSGDD [05/21/04] 6.00 is loaded and operational. IBM OS/2 LAN Netbind PRO0021: A general failure occurred when the program tried to bind TCPIP_NIF to R8110_NIF.

My protocol.ini uses minimal entry for r8110

[R8110_nif]

DriverName? = R8110$

I tried also with suggested settings for beta1, but still same problem.

Please adjust trac component and version, I can't set R8110 and 0.1.2