Custom Query (41 matches)

I have a Realtek ethernet driver working with RTL8169 driver from eCS 2.0. For that driver I need to specify NetAddress?. I installed beta 1, and networking does not start.

Output of ifconfig and lantran.log are attached. PCI dump of the ethernet adapter follows.

Bus 3 (PCI Express), Device Number 0, Device Function 0

Vendor 10ECh Realtek Semiconductor Co., Ltd. Device 8168h RTL8111/8168B PCI Express Gigabit Ethernet controller Command 0007h (I/O Access, Memory Access, BusMaster?) Status 0010h (Has Capabilities List, Fast Timing) Revision 03h, Header Type 00h, Bus Latency Timer 00h Self test 00h (Self test not supported) Cache line size 32 Bytes (8 DWords) PCI Class Network, type Ethernet Subsystem ID 0DC4105Bh Unknown Subsystem Vendor 105Bh Foxconn International, Inc. Address 0 is an I/O Port : E800h..E8FFh Address 1 is not present or not configured! Address 2 is a Memory Address (64-bit, Prefetchable) : DEFFF000h Address 4 is a Memory Address (64-bit, Prefetchable) : DEFF8000h System IRQ 11, INT# A Expansion ROM of 128 KiB decoded by this card, currently disabled New Capabilities List Present:

Power Management Capability, Version 1.2

Supports low power State D1 Supports low power State D2 Supports PME# signalling from mode(s) D0, D1, D2, D3hot, D3cold PME# signalling is currently disabled 3.3v AUX Current required : 375 mA Current Power State : D0 (Device operational, no power saving)

Message Signalled Interrupt Capability

MSI is disabled MSI function can generate 64-bit addresses

PCI Express Capability, Version 2

Device/Port? Type :

PCI Express Endpoint Device

Device Capabilities :

Unsupported Request Severity is Fatal

Device Status :

Correctable Error Detected Unsupported Request Detected AUX Power Detected

Link Capabilities :

Maximum Link speed : 2.5Gb/s Maximum Link Width : x1 Link Port Number : 0

Link Control :

Common Clock Configuration In Use

Link Status :

Current Link speed : 2.5Gb/s Current Link Width : x1

MSI-X Capability Vital Product Data Capability

VPD Data not present

I bought a new mainboard Gigabyte GA-870A-UD3. The Revision 2.2 has a gigabit LAN chip RTL 8111E. I don't know whether the "E" of this chip causes my troubles.

If I install your r8110-0.1.3.zip in an installed eCS 2.1 with MPTS, I get the text "Realtek 8110/1Gb PCIe MAC Driver 0.1.2-BETA Copyright (c) 2010 Mensys BV DEBUG VERSION R8110$ loaded" during bootup, but no network connection is possible.

If I install the driver during eCS 2.1 installation, the bootup text is "Realtek RTL 8110/1G NIC OS/2 Driver v.0.1.2 beta 2011-02-14", and the driver works fine in eCS. But if I reboot with Win XP or openSUSE 11.4 I can't connect to the network. In XP the device manager shows something like "This device can't be startet (Code 10)". Only a cold reboot removes the error.

In both cases 0.1.2 is shown, but it is the driver version 0.1.3!