Custom Query (34 matches)
Results (7 - 9 of 34)
| Ticket | Resolution | Summary | Owner | Reporter |
|---|---|---|---|---|
| #32 | NoChangeNeeded | AHCI doesn't recognize Intel Generic ICH7 SATA controller | ||
| Description |
version 1.30 I added the /g:8086:27c0 to get the driver to recognize the controller. When it tries to load against the controller, it gives me this error on boot: Found AHCI device Intel Generic (0:31:2 8086:27c0) class:0x01018f OS2AHCI: couldn't determine MMIO base address No adapter found OS2AHCI driver *not* installed I suppose that the 0:31:2 could have been 0:31.2. I could have copied it down wrong. I have the type ibms506$ output as well as a log from a d:2. I'd attach them now I if could figure out how to do that. I'll work on getting them added to this ticket. |
|||
| #31 | fixed | Disk geometry incompatible with DANIS506 | ||
| Description |
When running a WD10EADS on OS2AHCI, disk geometry is not reported properly (see also ticket #29). LVM says:"DISK 1 reports a corrupt partition table". When running the HD via DANIS506 everything works fine. The problem also exists in version 1.29 (different to ticket #30). |
|||
| #29 | invalid | Boot hang with JMicron Generic (197b:2363) device | ||
| Description |
After first boot sequence eCS hangs during checkdisk session (see attached screenshot). System boots without problem when using DANIS506 (JMicron Adapter supports also traditional IDE). One HD is running on this controller (WD10EADS), this drive is AHCi-capable. Three other HD's are connected to the Mainboard's SB 700 controller, which is running in IDE mode. A serial debug log is also attached to this ticket. It ends exactly after the third checkdisk should occur. After pressing the reset-button on the machine, the second attached trap000d in OS2BOOT occurs. It does not occure during boot w/o serial debug log. |
|||
