Custom Query (34 matches)
Results (4 - 6 of 34)
| Ticket | Resolution | Summary | Owner | Reporter |
|---|---|---|---|---|
| #27 | worksforme | OS2AHCI can not operate on large Disks (2 TB) | ||
| Description |
When running a 512MB and a 2TB disk on an Intel NM10/ICH7 controller (8086:27C0) in IDE mode, everything works fine. Changing to AHCI-mode, only c-drive with 512 MB is visible. DFSEE states: ERROR disk nr 2 : EBR at 0x0000fe01, Cyl:1 cannot be read! RC:087 (Hopefully this is not a known problem, I did not find a similar ticket) |
|||
| #29 | invalid | Boot hang with JMicron Generic (197b:2363) device | ||
| Description |
After first boot sequence eCS hangs during checkdisk session (see attached screenshot). System boots without problem when using DANIS506 (JMicron Adapter supports also traditional IDE). One HD is running on this controller (WD10EADS), this drive is AHCi-capable. Three other HD's are connected to the Mainboard's SB 700 controller, which is running in IDE mode. A serial debug log is also attached to this ticket. It ends exactly after the third checkdisk should occur. After pressing the reset-button on the machine, the second attached trap000d in OS2BOOT occurs. It does not occure during boot w/o serial debug log. |
|||
| #31 | fixed | Disk geometry incompatible with DANIS506 | ||
| Description |
When running a WD10EADS on OS2AHCI, disk geometry is not reported properly (see also ticket #29). LVM says:"DISK 1 reports a corrupt partition table". When running the HD via DANIS506 everything works fine. The problem also exists in version 1.29 (different to ticket #30). |
|||
