id	summary	reporter	owner	description	type	status	priority	milestone	component	version	resolution	keywords	cc
17	os2ahci reports non-existent devices to smart queries	ukihelt	Steven Levine	"I have a small application that queries danis506.add for performance figures and SMART data using her interface to do so. On my machine in IDE mode, with only danis506.add 1.8.14 loaded, I get data for a single disk drive on '1m'. If I now load basedev=os2ahci.add then I suddenly start getting data for all master/slave devices up to 7m/7s! If I put my BIOS into AHCI mode only and REM out danis506 and boot only using os2ahci.add then I get the same mis-reported drives. In addition, possibly due to the same problem, with os2ahci.add loaded, if I open a command prompt and type `type ibms506$` then I get an i/o error popup instead of the expected messages from danis506 about what disks and devices were discovered and their geometry.

Source and precompiled binaries for the application can be found on hobbes.nmsu.edu as dskmon10.zip"	defect	new	minor	Release-1.8.16	danis506.add	1.8.13