Building the drivers =

The original build instructions are at ​http://svn.netlabs.org/repos/uniaud/GPL/trunk/howtobuild.txt

The new build instructions are here.

The first thing you need to do is install ​OpenWatcom. You need to install at least the OS/2 C and C++ support for OS/2 16-bit and 32-bit targets.

Next you need to install the IBM Driver Development Kit (DDK) Toolkit. IBM no longer makes this toolkit publically available, so if you need a copy TBD. The long term plan is to implement open source versions of the DDK Toolkit headers in OpenWatcom which will eliminate the need for the DDK.

Now you need to build Makefile.inc. This file configures the uniaud makefiles for your specific directory layout. Assuming directory layout described in Getting the sources, run

cd uniaud32_workspace
trunk\configure

and answer the questions. Review the generated Makefile.inc and verify that the pathnames are correct. This script has some issues.

Once you are satisfied, copy the file to the root of your uniaud16 workspace. This is the uniaud16_workspace referred to in the examples Getting the Sources. There really should need to be only one instance of this file, but this will have to wait until the makefiles get some rework.

To build uniaud32, do whatever you do that make the OpenWatcom available in the current command line session and then

cd uniaud32_workspace\trunk
!m_kee.cmd

!m_kee.cmd is a simple wmake front-end.

A full build should take about 15? minutes on reasonably capable hardware.

To build uniaud16, do

cd uniaud16_workspace\trunk
wmake -ms -f makefile.os2

A full build should take less than 5? minutes on reasonably capable hardware.