Custom Query (20 matches)

Trying to install eCS 2.2 Beta II to a new drive. Used DFSee to set geometry, create new mbr, and a JFS partition. At the end of phase 1, the reboot hung with the 4 lines of Air-boot v.1.1.0 text displayed, but no menu.

There is only one drive in the system at this point, a SATA 500 Gib Seagate ST500DM002.

Am going to try earlier versions of Air-Boot, v.1.0.7, and V.1.0.8.rc3.

Taking the simplest possible scenario:

1. boot DFSee to wipe the start of the disk
2. boot eCS installation disk to create a partition table
3. re-boot eCS installation disk to create a single primary partition and then add Air-Boot
4. boot from hard drive. Air-Boot says: "Your system has at least one broken partition table entry or your hardware contains bad sectors. System halted."

Instead of a diskette drives, I had the system builder insert a multi-card reader, which plugs into a USB header ... unplug it and, hey presto, everything works.

Good Afternoon,

On my PC I have installed on disk 1 Windows 7 and EcomStation? 2.2, I have a second disk for Archive, and now I installed a third disk 250GB, where I installed Ubuntu, this disk I have a Primary partition from 50 Gb (/) and a logical partition 186 (/home) end the rest for the swap file. I reinstalled with ecomstation air-boot but when I chose Linux i get the failure "Load Error! Iḿ still able to choose for W7 and Ecomstation. I can only start linux when I chose in the bios the disk with Linux to start up

I hope you can help, in the manual on page 28 I worked out the steps to replace Grub, also I repaired Grub then what was described on page 28 isn the solution for me. After that I had to reinstall Ubuntu.

Thanks already for suggestions